Yasushi,
can you provide a photo of the hinge in its assembled state?
--- In This email address is being protected from spambots. You need JavaScript enabled to view it., "akahori" wrote:
>
> I am assembled without a problem. I must not cut an obstacle?
> The reason why I sew it with carbon will be that I reduce weight.
>
>
> Yasushi Akahori from Japan
>
>
>
Original Message
> From: Dewey
> To: This email address is being protected from spambots. You need JavaScript enabled to view it.
> Sent: Thursday, February 02, 2012 9:14 AM
> Subject: [Carbondragonbuildersandpilots] Tail surface hinge assembly
>
>
>
> Can anyone explain how to assemble the rudder to the vertical stab once
> the airplane is finished? I can't see how one would insert and fasten the
> pivot bolts through the hinges. Would not the gap covers interfere with
> assembly? Also, why not bolt the hinges to the spars instead of the "sewing"
> with roving? This seems gimmicky.
> The same applies for the elevator and horizontal stab as well. Photos
> would be nice.
