thanks, I'll see if I can't scrounge up some mechanical properties for the spruce. And the plywood. Plywood is birch? 3-ply? 1/32?
--- On Thu, 4/5/12, This email address is being protected from spambots. You need JavaScript enabled to view it. <This email address is being protected from spambots. You need JavaScript enabled to view it.> wrote:
From: This email address is being protected from spambots. You need JavaScript enabled to view it. <This email address is being protected from spambots. You need JavaScript enabled to view it.>
Subject: Re: [Carbondragonbuildersandpilots] step 2
To: This email address is being protected from spambots. You need JavaScript enabled to view it.
Date: Thursday, April 5, 2012, 5:39 PM
Kenny,
The file is of aft rib #2 and the material call out is spruce 5/16 and plywood gussets.
Regards,
Charlie Johnson
Ogden, Utah
In a message dated 4/5/2012 7:15:45 A.M. Mountain Daylight Time, This email address is being protected from spambots. You need JavaScript enabled to view it. writes:
Got the model read into the analysis software OK -- thanks a bunch!
I will try and get something going over the weekend. At least I should be able to tell approximately what the strength of the original rib was.
Which rib is this, by the way?
Is the material call-out for spruce, pine, or fir?
